ECU Accessories
X10 communicates between transmitters and receivers by sending and receiving signals over the existing electrical wiring in your home. The X10 Transceiver then sends commands to the X10 modules. A separate X10 module is required for each appliance you want to control.
 |
Wall Switch
Replace your existing wall switch with this in-wall X10 light switch for direct and remote control of your lights.
|
 |
X-10 Radio transceiver
It Converts Wireless Signals Into Powerline X10 Signals
|
 |
Universal Module
Use Your X10 System to Control Low-Voltage Devices
|
 |
2-Prong Appliance Module
For on/off control of 2 prong appliances up to 15 amps.
|
 |
Lamp Module
For control of lamps of 40-300 watts. Supports dimming.
|
 |
3-Prong Appliance Module
For on/off control of 3 prong appliances up to 15 amps.
|
 |
AbleNet/Tash IR Bed Control
IR Bed Control works with Pilot Pro and Pilot Pro. Must be installed by trained personnel. Only available for specific beds – check with AbleNet for availability as models change frequently and each unit is custom made. Hand pendant may be required at an additional cost.
|
Product HCPC Codes
Wheelchair K0108
Bed Controllers E2205
General Accessories A9999/E9999